jwhhydraulics.com

TILT-N-LOAD TRUCKS

John & Sons Welding

Choose from a single axle unit for up to 10,000 LBS or this dual axel truck for up to 40,000 LBS.

A hydraulic winch pulls the bins onto the rails rather than a cylinder.
This offers a more cost effective solution as well as a lower chassis height.



Loading pitch is not as steep as a traditional Roll-Off.
This is due to a 6 inch drop at the end of the rails as well as the lower chassis height.


The operator has full controls both inside the cab as well as on the chassis.

40,000 LB Tilt-N-Load Specifications

Standard Features:

  • Pull Master winch M12-3-97-1 (40M lb. capacity).
  • 6" bore lifting cyl. outside frame facing front (50M lb. capacity).
  • Hoist safety props.
  • PTO direct mount P350 Commercial pump.
  • Commercial 2-s and outside pool valve.
  • One tarp box.
  • 5/8" cable 50' long.
  • 30 gal. oil tank with breather cap, shut off valve, inside strainer and outside Gresin filter, and side oil gauge.
  • One rubber mounted back up light on each side.
  • Mud flaps on front and rear of tandem with splash plates.
  • 4X8X3/8 rectangular tubing frame.
  • Lights on bottom rail.
  • Heavy-duty stoppers.
  • Two wire hoses.
  • Enamel painted (one colour).
  • Optional:

  • Additional tarp box.
  • Roller at rear.
  • High performance paint.
  • We customize our products to fit the needs of out customers.
    Other options are available by request.


    Back to Top